Problem with corner tranfer units
Posted: Tuesday 21 April, 2015 - 10:58
Hello,
I have a problem in my model with the Corner Transfer Units.
First of all a short statment:
The red conveyors and the corner Transfer units are plate pushing machines
All other conveyors are roller conveyors.
The bottom part of the model runs as it should.
But the top part do not.
The two products can only enter the corner units at the same time (in real life there is only one vertical Conveyer and one corner Transfer unit that can move two products at the same time)
A hydraulic pusher pushes the products in horizontal direction from the end into the short red conveyor.
So you can see that the corner units dont work as one machine.
I donĀ“t know how to solve the problem
I have a problem in my model with the Corner Transfer Units.
First of all a short statment:
The red conveyors and the corner Transfer units are plate pushing machines
All other conveyors are roller conveyors.
The bottom part of the model runs as it should.
But the top part do not.
The two products can only enter the corner units at the same time (in real life there is only one vertical Conveyer and one corner Transfer unit that can move two products at the same time)
A hydraulic pusher pushes the products in horizontal direction from the end into the short red conveyor.
So you can see that the corner units dont work as one machine.
I donĀ“t know how to solve the problem