Hello,
My last post was about the scale factor. The tape measure tool works and the scale factor is 200.
The next step is to draw the area. But when we put a entry/exit area at the beginning of the area and at the end of the area an error appear: Could not create the Explicit Corridor Map(ECM) network.
I think the area is too big for PD?
Arno
Area too big?
- MatthijsJongboer
- Posts: 200
- Joined: Thursday 11 November, 2010 - 14:12
Re: Area too big?
Hello Arno,
Are you able to create a small model where the error does not occur?
Gr. Matthijs
Are you able to create a small model where the error does not occur?
Gr. Matthijs