Call Operator
Posted: Monday 01 October, 2012 - 13:55
Hi there,
Currently I'm working on a model to simulate a sorting machine. Each output conveyor has an assembler to stack products on a pallet. This operation must be supported by an operator. However, after the operator is called, the assembler already starts operating even when the operator is still on his way walking to the assembler.
On Init all conveyor output's are closed. The sorting conveyor has a closed output. When a certain content is reached, the output openes. Then the assembler calls the operator in the Trigger on entry chn. 2-n. The operator is member of a team, the team is connected to input channel 3 of the assembler. The code on Trigger on entry chn. 2-n is:
Why does the assembler already start working when an operator and how should I model this? Tnx in advance!
Currently I'm working on a model to simulate a sorting machine. Each output conveyor has an assembler to stack products on a pallet. This operation must be supported by an operator. However, after the operator is called, the assembler already starts operating even when the operator is still on his way walking to the assembler.
On Init all conveyor output's are closed. The sorting conveyor has a closed output. When a certain content is reached, the output openes. Then the assembler calls the operator in the Trigger on entry chn. 2-n. The operator is member of a team, the team is connected to input channel 3 of the assembler. The code on Trigger on entry chn. 2-n is:
Code: Select all
If(
Content(in(2,c)) >= valConvCutoff-1,
CallOperators(in(3,c),1,1)
)