Hi Team,
I would love to draw a simple engine block, which would replace the atom product of my model when shown on 3D, but am having problem doing this.
i would also like for my first set of servers to be able to specify a product whenever it goes into a server and then give the product the saved cycle time i.e. I have three different cycle time for the products e.g red product-7mins, blue -8mins and green - 9mins and i want the servers to allocate each cycle time allocated to each product whenever each product enters the server.
Any help with this would be grateful
Thanks
Ibukun
Drawig an Atom product and creating variable cycle time
Drawig an Atom product and creating variable cycle time
- Attachments
-
- CylinderBlock6.mod
- (302.29 KiB) Downloaded 311 times
Re: Drawig an Atom product and creating variable cycle time
Dear Ibukun,
Please refer to this link about the 3D problem: post130.html#p70
for the second question, using these codes in Trigger on Entry of Server:
And ascribe Label([CycleTimeContainer],first(c)) in the CycleTime of that Server.
KR,
Josie
Please refer to this link about the 3D problem: post130.html#p70
for the second question, using these codes in Trigger on Entry of Server:
Code: Select all
case(
WhichIsTrue(
Icon(first(i)) = 26,
Icon(first(i)) = 28,
Icon(first(i)) = 23
),
Label([CycleTimeContainer], i) := mins(7),
Label([CycleTimeContainer], i) := mins(8),
Label([CycleTimeContainer], i) := mins(9)
)
KR,
Josie
Re: Drawig an Atom product and creating variable cycle time
Hi guyz,
I would like to reduce the idle time and increase the busy time, whats the best way for me doin this?? After inputing the MTF and MTR, whenever i run the model the machines tend to breakdown at its own suited time, n not the required time its suppose to breakdown......help with this would be grateful
I would like to reduce the idle time and increase the busy time, whats the best way for me doin this?? After inputing the MTF and MTR, whenever i run the model the machines tend to breakdown at its own suited time, n not the required time its suppose to breakdown......help with this would be grateful
- Attachments
-
- CylinderBlock6.mod
- (322.79 KiB) Downloaded 296 times
Re: Drawig an Atom product and creating variable cycle time
Did you try the option "busy time" in the tab "specific" of the server? Then the server will break down based on the busy time. The way you use the breakdown option now, the server will get a break down after a certain simulation time no matter if it's busy or not.