Hello,
I have problem with assembling two products (p1 and p2) in two different boxes (p1: 6 per box, p2: 4 per box) and after that assembling this boxes on container (product p1: 3 boxes and p2: 4 boxes ) and stocking in warehouse.
I attached .mod with my set up. I'll be very grateful for help.
Labels and Assembling
- HarryBunnik
- Posts: 362
- Joined: Monday 07 February, 2011 - 11:22
Re: Labels and Assembling
Ha Krzysztof1997,
You're rather close. You already use a label "opakowania" in the assembler. However, you haven't assigned this label yet to the product that is entering the assembler through channel 1 (the container in which the other products are packed.
I've added a simple formula on the Exit Trigger of the source names "Boxes", which will declare a label "opakowania" to each product leaving the source with either a value 1 or 2 (alternating).
i.opakowania := Mod(output(c), 2) + 1
Then the assembler takes either column 1 or 2 from the B.O.M.
I hope this helps you further,
Regards,
Harry
You're rather close. You already use a label "opakowania" in the assembler. However, you haven't assigned this label yet to the product that is entering the assembler through channel 1 (the container in which the other products are packed.
I've added a simple formula on the Exit Trigger of the source names "Boxes", which will declare a label "opakowania" to each product leaving the source with either a value 1 or 2 (alternating).
i.opakowania := Mod(output(c), 2) + 1
Then the assembler takes either column 1 or 2 from the B.O.M.
I hope this helps you further,
Regards,
Harry