InControl Community

Hello Harry

Thanks in relation to the queue question, that helped resolving my issue.

In relation to the excel, it worked at the start where it would not open up the excel when i connected, if i did not have the "Excel visible at startup" checked. This has been occurring lately on one of my ...

Hey again

An additional question in relation to my ExcelActiveX atom. I have the "Excel visible at startup" unchecked, but it still keeps on opening up visibly when i connect to my sheet. If i close the document it disconnects, and re-connecting opens it up, so it becomes visibly again.

Regards ...

Hello Harry

Thanks for the help so far, i am currently using the external solution you suggested with a table, and it works fine.

I have another question in relation to queue discipline. I am currently using the function "findqueuepos()" in order to arrange the queue in relation to a label value ...

Hello Harry

Thank you, this gives some insight in where the solution may go. Although i am still having a challenge, as the number of product which can enter is several more, and the status which is required depends on what happens.

For an example when there is a product on the outbound conveyor ...

Hello

I hope you may be able to help me again. I am having issues determining the status(Busy, idle, blocked, down) of a process i have modeled which consist of the following.
Conveyor --> Process --> Conveyor.

In real life the conveyor is a part of the machine, and referred to as the inbound and ...

Hey Harry.

Nevermind, I got it to work. Just had to use the userevent at two different locations.

Best regards,

Jesper

Hello Harry

Thanks!

I have tried as suggested, but i can only get it to delay the opening of the output for 20 sec. I need it to first wait until the amount of products in both conveyors and the process are gone, and then start the 20 seconds delay.
If it is full and want to wait until my variable ...

Hello

I hope someone is able to help me with another conveyor issue.

I have attached my model.

I have a machine that can contain three products. One product on the inbound conveyor, one on the outbound conveyor, and the one in the middle which it can process. As this is not possible to model ...

Hello

I am currently trying to model several Robotic assembly cells, but before I start scaling the model I want to ensure that all the mechanisms are in place. The scaling will both be in relation to the number of AGV’s, number of sub-components required, cells constructed and inventory buffers ...

Hello Harry

Ahh, my mistake.

Thanks!

Best regards,
Jesper