InControl Community

Hi Harry,

I have just tested the new atom, and everything is running smoothly!! Thank you very much for the help. It speeds up my 3D-modelling quite a bit!

Thanks!!

Hi, I disabled all the pictures which were loaded onto planes and it didn't make a difference. I looked at my performance of my processes and as you can see the Maximum Frequency (The blue line in the CPU-graph) goes to max when I load the 3D-viewer. The fluctuation in the graph before the "Ste...

Hi Harry

Here is the model. I dont think the attach model is enabled in PM.

Hi,

Tried it already and unfortunately it didnt work. Can you see if my specs are the cause to the problem?

Could it be some settings in my chache? Its like something is getting filled during the time if have got the model open and then slows the model down. I have experienced something similar on this laptop earlier when I was running a model for 400 hours. After opening the model and running the first s...

And here are the pictures. Obviously the other thing I tried didn't work

Hi, Well im not running the simulation. When I enter the 3D view the simulation is stopped and im just moving around in the 3D-viewer. And after 2-3 minutes the performance get very low. At the moment I have only built three planes extra into the model with their own texture. Here are the screenshot...

Hello I am currently building the 3D part of my model, and when I ED and next the 3D view everything is running smoothly and nice. Within a couple of minutes the performance decreases drastically and when moving around the 3D view it is going very slow. What I dont understand is why it runs smooth i...

Thank you for your proposal. Unfortunately I cannot get the User Event atom to work. I have not used it before, so might be making beginners mistakes.... I have set the Time [s] = 3600 and set the following event trying to write the data to the table: do( Setdata(1,output(c),label([cumulativesetupti...

Hello Incontrol I am currently doing a model in which I have a table where I write the setup time and proces time. What i need is a script that can tell me the time in the model and not only just when an atom leaves an atom. The Statusmonitor-atom is doing that but it does not allow me to see the da...